Emergency Water Heater Repair in Murray

Water Heater Repair in Murray, Utah - Murray sits in the middle of the Salt Lake Valley, and its housing averages just over five decades old. That age shows up in the utility rooms. Heaters here are often wedged into original closets built around a 40-gallon tank, which quietly limits what you can put back in. A modern high-efficiency unit is frequently taller and wider than the one it replaces, and clearances that passed inspection in 1970 may not pass now. Measure before you shop, and have someone look at the vent run while they are there. That is the constraint that most often forces a change of plan partway through a Murray replacement. The companies above deal with it routinely.

Water Heater Insights for Murray Gas: Enbridge Gas Utah Electric: Rocky Mountain Power

50,637
Population
22,000
Housing Units
52 yrs
Avg. Home Age (built ~1974)
Zone 5B
Climate Zone 29°F avg. January
11%
Homes with Tankless
68
Replacements/yr per 1,000 homes
Very Hard  |  12 grains/gallon

Very hard water causes rapid scale buildup — most water heaters in Murray need flushing every 6–12 months.

Murray was once home to a major ASARCO copper smelter — the industrial heritage means many older Murray homes predate modern plumbing standards.

Filter:
Showing 18 of 18 companies

Frequently Asked Questions

What is the total installed cost of a 50-gallon water heater?

In Utah, a 50-gallon gas water heater — unit plus installation — typically runs $900–$1,400 for a mid-range model from a licensed plumber. A 50-gallon electric unit is slightly cheaper: $750–$1,200 installed. Premium brands (Bradford White, A.O. Smith Signature Series) sit at the higher end; builder-grade units at the lower end. The 18 companies serving Murray vary in pricing — getting 2–3 quotes is the fastest way to find a fair number.

How long does a typical water heater last?

Traditional tank water heaters last 8–12 years; tankless (on-demand) units typically last 15–20 years with proper maintenance. Hard water — common in many Utah cities — accelerates wear on both types. If your unit is approaching these ages and requiring repairs, replacement is usually the more cost-effective long-term choice.

Why did my water heater pilot light go out?

The most common cause is a worn thermocouple — a small sensor that holds the gas valve open when the pilot is lit. When the thermocouple weakens, it can no longer reliably signal the valve, and the pilot extinguishes. A clogged pilot orifice, a strong draft, or a temporary interruption in gas supply can also cause it. Relighting the pilot following the label instructions is safe to try once; if it won't stay lit, the thermocouple (a $10–$25 part, about an hour of labor) is the likely fix.

What is Legionella and how do I prevent it in my water heater?

Legionella is a waterborne bacterium that causes Legionnaires' disease -- a severe form of pneumonia -- when inhaled as aerosol droplets from showers or faucets. It thrives in warm water between 77 and 113 degrees Fahrenheit. Prevention: keep your water heater set at 120 to 140 degrees, flush the tank annually to remove sediment where bacteria can shelter, replace a depleted anode rod, and do not let the system sit stagnant for extended periods. High-risk households should discuss options with a licensed plumber.

Emergency Water Heater Services in Nearby Cities

Scroll to Top